This product is a refractory ceramic fibre blanket suitable for wrapping around your hot end to insulate it.

The blanket can be cut into a strip that then wraps around your hot end.  Use our 10mm Kapton/polyimide tape to hold it in place.

Insulating your hot end:

• Reduces warm up time
• Improves temperature stability
• Reduces unwanted convection heat transfer to other parts of you printer.
• Reduces the effects of cooling fans and drafts
• Reduces power consumption.

The blanket is approximately 3mm thick and can be easilly cut to size or even split with a sharp blade.

Supplied in square sheets 150 x 150 x 3mm

Rated for over 1000°C

Thermal conductivity 0.1W/mK @ 200°C